4. Preparing the transceiver
Makesurethefollowingitemsaresuppliedinthepackagebefore
youstartusingyourtransceiver:
Transceiver;•
Desk/wallsupport•
NiMHbatterypack•
Beltclip;•
Desktopchargeralongwithadaptor;•
2-waycarlightercharger;•
Usermanual;•
If any of the above is missing or damaged contact your supplier
immediately.
4.1 Installing and removing the belt clip
Withthebeltclipyoucaneasilyattachthetransceivertoyourbelt.
Thecliphowever,mustberemovedinordertoinstallorchangethe
batteries.Toremovethebeltclipfollowtheinstructionsofpicture1.
Toxtheclipbacktothedeviceslotitintheguidesatthebackofthe
transceiveruntilitclicksintoplace.
4.2 Installing and removing batteries
ThetransceiverisoperatedbythesuppliedNiMHbatterypackorby
4optionalAAbattery.Thesecanbeeitheroneoftwotypes:
• RechargeableNiMH(1,2 V)- availableindifferentcapacity (in
mA/h).Batterieswithhighercapacitywillsupplylongercharger
butwillrequirelongertimestorecharge.
• Non-rechargeablealkaline(1,5V)
! Do not install rechargeable and alkaline batteries at the same
time in your transceiver. Always use the same batteries as a
set (type and make) so that you can be sure their level of
charge is the same.
! If you do not use the transceiver for a long time remo ve the
batteries/ battery pack.
4.2.a Installation
1)Removethebeltclipasexplainedinparagraph4.1;
2)Openthebatteriescompartmentasshowninpicture2;
3)Insertthebatterypackintothebatterycompartmentasshownin
picture2.
4)Replacethecoveronthebatteriescompartment.
5)Replacethebeltclip.
! If you use the batteries, be careful to insert them with the
correct polarity as illustrated inside the compartment.
! Be careful to snap close the battery cover.
Comments to this Manuals