Midland BT Ski User Manual download pdf (Page 9)

UK

9

Resetting all paired devices

Sometimes you may nd it necessary to delete

all the pairing references stored in the BTSKI

unit (reset operation).

To perform this operation, switch off the BTSKI

and keep pressed the “Control” button. The red

led turns on. Simultaneously press and hold

down the “Volume +” and “Volume –“ buttons

for 4 seconds.

The Blue Light will be lit on for 1 sec.

This procedure deletes all the paired Bluetooth

devices stored in the memory and it is therefore

possible to start a new “clean” pairing session.

Using the wired audio input

Your Midland BTSKI is also supplied with a wired

audio input (labeled AUX), that can be used to

connect an audio source, like an iPod (or any

other MP3 Player) or a PMR446 transceiver

for communications in group or for a coverage

increase. The wired audio input allows a higher

range of coverage respect to what granted with

Bluetooth technology.

Priority: the wired audio input has the lowest

priority when compared to the other Bluetooth

connections (including the Intercom) and will

therefore always be disabled when another

Bluetooth communication is opened.

Using a i-Pod/MP3 Player

Listening to music

To listen to music from the wired input, connect

the audio source using the cable supplied with

the BTSKI unit. The volume level is automatically

adjusted by the AGC system, which means that

you only need to adjust the volume of your iPod/

MP3 player to a level that will allow you to listen

to music in normal speed.

Attention: never set the volume of the MP3

Player to the maximum possible.

Hint: We recommend that you perform a few

tests adjusting the volume of your iPod/MP3

player so at the normal speed the Headset vo-

lume is suited to your needs. The AGC system

will automatically increase the volume on higher

speed. Make a note to remember this setting for

future trips.

Attention: the volume adjustment, (“Volu-

me+” and “Volume –“) buttons, cannot be

used to adjust the volume of the wired audio

source(eg MP3 player).

Enabling/disabling the wire input

The wire input can be enabled and disabled

› Enabling: double click the “Control” button

(you will hear one audio conrmation tone).

› Disabling: double click the “Control”

button(you will hear two audio conrmation

tones).

Attention: this function is available only if

there is no music active via Bluetooth.

Using a Two Way Radio transceiver

To be able to use the transceiver, it is necessary

to purchase a specic cable (sold separately)

in order to connect the radio to your Midland

BTSKI:

Some manufacturers radios use a different pin

conguration, so we recommend that you ask

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments