Midland BT NEXT User Manual download pdf (Page 4)

4 - Midland BT Next midlandusa.com

English

Description of the audio kit

The audio system includes two ultra-at

stereo speakers and two interchangeable

microphones, which are both supplied with

a bracket and wired connection.

Attaching the stereo speakers

The two stereo speakers have a Velcro/adhesive strip that aids their attaching into

your helmet.

Beware not to completely cover your ear with the speakers, you must always be

able to listen to the trac sound and your indicators.

The microphone can be xed onto the helmet in two ways:

Boom Microphone

Place the section with the Velcro/adhesive strip between the padding and the

rigid cover of the helmet, so that the microphone is correctly positioned in front of

your mouth and that the white symbol is facing your mouth. This type of micro-

phone is suited for Open Faced and Flip Front helmets.

Wired microphone

Using the Velcro/adhesive strip, place the microphone inside the helmet in front

of your mouth. This type of microphone is more suited for Full Faced helmets. The

mini connector on the microphone allows you choose the microphone that best

suits the helmet you are using.

Audio kit jack

The audio kit must then be connected to the central jack of the Midland BTNext

unit using the “L” shaped connector.

Description of the installation brackets

The Midland BTNext can be xed onto the helmet in two dierent ways: By either

using the plate with bi-adhesive strip, or the clamp. These methods allow you to

safely “x” the BTNext unit onto your helmet and to remove it at any time in order

to recharge or store it.

Plate with bi-adhesive strip

The mounting plate has a bi-adhesive strip on one

of its sides. To x the plate in place, clean the ap-

plication area on the helmet surface, remove the

bi-adhesive lm and place the mounting plate on

the helmet by keeping it contact with the surface

for a few seconds.

Screw Clamp

Using the Allen Key, loosen the two screws on the clamp and place the rear plate

between the helmet padding and the external rigid protection. Then, tighten the

two screws in order to rmly x the clamp in place. Inside the clamp is included a

small plastic spacer that can be removed to give a tighter t if required.

Fitting and removing your Midland BTNext

The BTNext can be easily tted onto the helmet by sliding it downwards so that

it ts into the slot of the selected mounting device (plate with bi-adhesive strip

or clamp). BTNext is maintained in position thanks to the mounting clip located

on the upper section.

To detach the BTNext, simply press the clip (A) and push the unit upwards.

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Midland BT NEXT User Manual Page 4

Comments to this Manuals

Related products and manuals for Communication Midland BT NEXT