Midland ER300 User Manual download pdf (Page 6)

ER300 Owner’s Manual

midlandusa.com

Page 6

Powering Your ER300

USB Charge Cable: Before the ER300 is used, the internal

rechargeable battery pack should be charged with the USB

charge cable until the battery indicator icon indicates a full

charge. To charge the ER300 with the USB cable, switch the

power source switch to the “Li” position. Then, insert the USB

charge cable into a USB power source and plug the mini USB

connector into the port labeled “USB In” on the side of the radio.

The CHARGE indicator light will be lit when the USB charge

cable is plugged in. The battery icon on the LCD will flash as

the battery charges. When the Li-ion battery has reached full

charge, the battery icon will stop flashing and will have 3 bars.

It will take approximately 5.5 hours to recharge a completely

depleted battery pack using the USB charge cable.

Rechargeable Battery: The included rechargeable battery

is located in the battery compartment and is charged by turning

the hand crank, exposing the solar panel to sunlight, or by using

the USB cable to attach to a USB power source. The battery is

specified as 3.7 VDC, 2000 mAh, lithium ion (Li-ion).

Warning:

• Only use Midland’s Li-ion battery pack.

• Do not attempt to charge alkaline batteries or any

battery packs other than the ones indicated in this

manual. This could cause leakage and damage to the

radio.

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

No comments

Midland ER300 User Manual Page 6